MEGATEC/Q1 PROTOCOL USB DRIVER DOWNLOAD

If this does not help, try running the driver with at least ‘subdriver’, ‘vendorid’ and ‘productid’ options specified. Also usbhid-ups is the right driver for Eaton 5E. If not specified, the driver defaults to seconds 12 hours. The NUT support groups are probably your best bet for assistance: Home Questions Tags Users Unanswered.

Uploader: Shakalabar
Date Added: 18 May 2011
File Size: 63.43 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 87355
Price: Free* [*Free Regsitration Required]

The NUT compatibility table lists all the known supported models. Saved my life ;!

[Nut-upsuser] Blazer_usb driver almost supports Centralion Titan Elite, but not quite

Post as a guest Name. All results what did I get was that driver is not running and UPS is not recognized.

If you specified the runtimecalthe driver will attempt to do this. Sign up using Email and Password. If you want the driver to report a guesstimated battery. The temperature and protocok value is known to be bogus in some models.

Uses the timer defined by offdelay. Dee 1, 3 15 We also believe everyone should be able to afford it.

[Nut-upsuser] connection pb with blazer_usb with infusec UPS

It might be worthwhile checking the cables also. Home Questions Tags Users Unanswered. If this does not help, try running the driver with at least ‘subdriver’, ‘vendorid’ and ‘productid’ options specified. This is better than nothing but not by much.

  INTEL 82855 VISTA DRIVER

Only used if runtimecal is also specified. Please check your device availability with ‘lsusb’ and make sure you have an up-to-date version of NUT. In most cases, the driver will send a message to the system log when the user tries to execute an unsupported command. If any of the above calculations is giving you incorrect readings, you are the one that put in the values in ups. I want to be protkcol to recommend Pfsense to people but this is the one snag that’s stopping me.

[Nut-upsuser] Blazer_usb driver almost supports Centralion Titan Elite, but not quite

Ask Ubuntu works best with JavaScript enabled. Try -DD for finding out the strings to match.

For information about the core driver, see nutupsdrv 8. Reply Quote 0 1 Reply Last reply. Note that a value below 3 minutes, may cause earlier firmware versions to not switch on automatically, so it defaults to 3 minutes.

Not megstec/q1 on some hardware. Please check your device availability with ‘lsusb’ and make sure you have an up-to-date version of NUT. If this does not help, try running the driver with at least ‘subdriver’, ‘vendorid’ and ‘productid’ options specified.

  LOGITECH C9000 PRO DRIVER

Most UPS options around here are unknown generics which will hit similar issues. Note however, that this heavily relies on the values you enter and that the UPS must be able to report the load as well.

USB UPS management/control – Raspberry Pi Forums

NUT is enabled, however the service is not running! This takes two runtimes at different loads.

This is not reliable under load, as this only gives reasonably accurate readings if you disconnect the load, let the battery rest for a couple of minutes and then measure the open cell voltage. The acceptable range is Typically, this uses the runtime at full load and the runtime at half load.

Product information, software announcements, and special offers.